Part 5 of My Knot Series: the Highwaymans Hitch

Introduction: Part 5 of My Knot Series: the Highwaymans Hitch

About: I LOVE knots. As well as other things. I post random 'Ibles not even related to knots. Sorry if there's a delay of when I post my instructables.

The Highwayman's hitch is ideal for tying a rope to an object when you need a quick release. Just yank on the end that is not supporting the load to untie and completely remove the rope from the object it was tied to.
If you want to keep reading these, subscribe!



Step 1: Materials

  • Post, or similar thing to tie it to
  • Paracord 550, or rope

Step 2: First Bite

first, make a bite under the post with the short end on the right side.




bite- half loop.

Step 3: Second Bite and Up

make another bite with the left side of the rope and put it over the post and through the top bite. tighten.

Step 4: Right Bite

make a bite with the right side, and put it through the top bight.
Then pull the shorter rope to untie it when needed. Tie to horse or other thing with longer end.
Hope you liked it! If you have any problems, ask me in the comments!
Until next time, -TKG

Be the First to Share

    Recommendations

    • Build a Tool Contest

      Build a Tool Contest
    • Fruits and Veggies Speed Challenge

      Fruits and Veggies Speed Challenge
    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge

    3 Comments

    0
    nwlaurie
    nwlaurie

    10 years ago on Introduction

    Pleas take this constructively: the word is BIGHT not BITE (at least it is in all my knot books!)

    0
    godfish
    godfish

    Reply 10 years ago on Introduction

    "Pleas take this constructively:"? it's PLEASE NOT Pleas.