Peace on Earth Ornament

Introduction: Peace on Earth Ornament

This Ornament is designed to be printed on a dualstrusion 3D Printer, such as the MakerBot Replicator Dual or Makerbot Replicator 2x.

The dual extrusion globe was remixed from tbuser's Giant Hollow Two Color World, licensed under the Creative Commons Attribution - Share Alike license. In accordance to the contest official rules, in addition to the Creative Commons license, I have written permission from each contributor.

Step 1: Print the Dual Extrusion Globe

Use your slicing software to print the peace_on_earth_land.stl and peace_on_earth_water.stl in dual extrusion (preferably in blue and green).

Step 2: Print the Banner

Print peace_on_earth_banner.stl, preferably in red.

Step 3: Print the Banner Pegs

Print 2 copies of peace_on_earth_pegs.stl

Step 4: Print 4 Doves

Print 4 copies of peace_on_earth_doves.stl in White.

Step 5: Assemble

Assemble your ornament! Note that the entire assembled ornament fits inside a 3 inch cube.

3D Printed Ornament Design Challenge

Participated in the
3D Printed Ornament Design Challenge

Be the First to Share

    Recommendations

    • Plywood Challenge

      Plywood Challenge
    • Plastic Contest

      Plastic Contest
    • Battery Powered Contest

      Battery Powered Contest

    Discussions