Introduction: Pendant

This is just a small pendant I nicknamed "halfway to forever" based off of something from when I was a kid


Supplies

Onshape

like 1.5 hours free

something to make it a necklace

Step 1: Sketch

make 1/4 of the project and put the in between lines as a guide for later


Step 2: Extrude

self explanitory


Step 3: Chamfer

hit every edge on the top and bottom

after chamfer the ring section separately

Step 4: Sketch 2

make a half circle with a line in the middle then use it to revolve

Step 5: Mirror

mirror the extrudes across the front and right planes

Step 6: Done

print and enjoy