Introduction: Personalised Rubber Stamp
More by the author:
About: I'm an Industrial Designer. I've always had an interest in building things. I believe it's important for designers to be in touch with their materials and how to construct and manufacture the products they cre…
This was a christmas present I made for my mom. The container is made from mahogny wood turned on a lathe. The stamp is done from a photoshopped picture of my mom. I have an instructable in the works on this one. Will look into getting it done in the beginning of the new year.
Be the First to Share
Recommendations
Robots Contest
Lamps and Lighting Contest
3D Printed Student Design Challenge
7 Comments
11 years ago on Introduction
Easy guys :). I know this is not an instructable. Like I wrote, I'm working on making a complete instructable detailing from start to finish. I'm hoping to have it ready within a week as I need to reshoot some of the steps.
Reply 11 years ago on Introduction
I'd certainly like to see it when it's ready. Though it looks that you're running a bit behind schedule.
Reply 11 years ago on Introduction
I am, I know. I actually do have all the text for the ible in place, but I need to find the time to make a new one from scratch in order to reshoot some of the steps. Am considering just illustrating the steps.. Either way, I hope to have it up soon. Sorry for the delay.
Reply 8 years ago on Introduction
It would be a nice instructable even with a few illustrations. Would love to see the steps for the rubber stamp creation.
11 years ago on Introduction
This is a Show & Tell not an Instructable unless u show how to make from start to finish with all the Materials used. ( Good Job on the Stamp though )
11 years ago on Introduction
..hum. Yeah nice. But without the instructions on how to make it, it has no meaning to me.
11 years ago on Introduction
Well come on! I'm dying to see it!!!! :D