Introduction: Quick and Effective Splash/dust Protection for X100s
This is a quick way to protect your gear (Fuji's X100/s/t) against dust and possible splashes of water (just mind it's not waterproof!)
I think photos will explain everything ;)
I assume you have a lens hood AND any filter (UV, polarizer/anything) on your camera - filter is very important here as X100 series has one major "sealing" flaw: there is a gap on the front of the lens, through which small particles like sand, dust or water can penetrate camera.
Step 1:
Take off the lens hood and put your camera inside any plastic transparent bag.
Step 2:
Now try to attach lens hood back to your camera. It may be difficult if your bag is too thick - try thinner ;)
Step 3:
Grab a knife and carefully cut out part of the bag covering the lens.
Step 4:
Voila! You're done ;) When I was shooting ColorRun I taped the bottom of the bag, so it was quite well sealed.