Introduction: Recycled Leather Mud Flap for a Vintage Bicycle

About: Undergoing treatment for old bicycle addiction. I am doing very well and have cut down to ten.
It all started when I broke the end off my rusty front mudguard. I wanted to sort out the missing end of my front mudguard; in wet weather (never good when you have rod brakes) it was rather a wet ride. As you can see my bike is hardly pristine; its kept more or less in a state of "wanton neglect" the thought of a clean mudflap fixed to a rusty mudguard did not seem right. Many people make their own from plastic bottles and the bodies of plastic dolls; I thought that an old boot would be in keeping with the decaying nature of my bicycle.
The pictures tell the story; The boot was an old German Paratrooper boot with the sole missing but I think any old boot will do as long as the leather is still good and the boot is large enough.

You will need;
Your bicycle complete with its mudguard
An old boot
stout paper or card for the template
a drill and drill bit to suit the rivet size
A hand operated riveter and rivets
Dubbin or Nikwax

How to do it;
make a template,
fold it in half to ensure it is symectrical
offer it up to check it looks right on the mudguard, adjust as necessary
cut the leather (I have heard that you should soak the leather in water to make it easier to cut but I had no difficulty with ordinary scissors)
treat it with wax or dubbin on both sides,
drill and pop rivet it to the mudguard.

I used other scraps of leather for hub cleaners - but that is another instructable...

Finally go for a ride and enjoy it - but do look where you are going not at the mudflap -I accept no responsibility for riders colliding with milk floats or street furniture!

This is the link to the bicycle mud flap on Flickr

Enjoy; Ride free; keep old bicycles on the road
Bike Contest

Participated in the
Bike Contest

Instructables Green Design Contest

Participated in the
Instructables Green Design Contest