Sending SMS With Arduino || TC35 GSM Module

Introduction: Sending SMS With Arduino || TC35 GSM Module

About: Awesome Electronics Tutorials, Projects and How To´s

In this small project I will show you how to use a TC35 GSM module properly and how to use it with an Arduino Uno to send a SMS with it.

Step 1: Watch the Video!

This video gives you all the information you need, so you will not destroy the TC35 while you use. I will give you some additional tips in the next steps.

Step 2: Get Your TC35 GSM Module!

Step 3: Download the Schematic and Sketch!

Make sure to get the connections between the Arduino and module right by using my schematic. And don't forget to upload the code/sketch to the Arduino

Step 4: AT Commands?!

Here is the site where you can find all the AT commands for the module:

http://www.hughes.com/AT_Command_Reference.html

And also a manual for the board:

https://docs.google.com/document/d/1Nmkcos20_gqYwU...

Step 5: Success!

Now you should be capable of sending SMS with your Arduino.


Feel free to check out my Youtube channel for more awesome projects:

http://www.youtube.com/user/greatscottlab

You can also follow me on Facebook, Twitter and Google+ for news about upcoming projects and behind the scenes information:

https://twitter.com/GreatScottLab

https://www.facebook.com/greatscottlab

Be the First to Share

    Recommendations

    • Pi Day Speed Challenge

      Pi Day Speed Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Microcontroller Contest

      Microcontroller Contest

    6 Comments

    0
    RezaR46
    RezaR46

    3 years ago

    please can you help me, because i cant control relay with arduino and TC35 but the sms already to read

    0
    MiniKey
    MiniKey

    3 years ago

    where could i get a SIM card for this project?

    0
    jassuah
    jassuah

    5 years ago on Introduction

    please can you help me because i cant receive the sms but will display success

    0
    WaiB1
    WaiB1

    Reply 3 years ago

    Change the line "Serial.begin(9600);" and "mySerial.begin(9600);" to "Serial.begin(19200);" and "mySerial.begin(19200);", respectively. Then on the serial monitor, select the options "carriage return" and "19200".

    0
    resad indipa
    resad indipa

    Reply 4 years ago

    check your number