Introduction: Shower Head Plugged

You turn on your shower and nothing comes out. But, the water is flowing out of the spout below.

Step 1: Unloosen the Shower Head..

First you need to inpect the shower head for blockage. Use slipjoint pliers to unscrew the head from the supply tube.

Step 2: Once Loosened,

you can unscrew it the rest of the way with your fingers.

Step 3: Some Small Amount of Water

will come out.. don't get wet. Now, look down inside of your shower head and see if there's something in there. Usually there is only a small hole here and it plugs easily.

Step 4: Reinstall the Head.

Tighten by hand. If the tape stays on it will seal again. If not, you should add some plumbers tape or teflon paste here.

Step 5: Righty Tighty Lefty Loosey..

Once you tighten the shower head back onto the tube, test it. If it leaks tighten it some more. Be careful not to overtighten.

Step 6: With Some Luck..

you'll be a gettin' wet. It may even plug up again.. during your shower !  If it does.. you know what to do..Woof