Introduction: Simple IR Remote Tester Circuit.

By

Hello everyone, In this instructable we will be going to create a simple IR remote tester, that flickers LED whenever any button on IR remote is pressed.

Step 1: Gather the Parts

  • A breadboard
  • A LED
  • A 220ohm resistor
  • A TSOP382 IR receiver
  • 2 AA batteries
  • Some jumper or hookup wires

Step 2: Wiring

Hookup all the components according to the circuit diagram shown above.

Step 3: Done

Now, When you press any button on the IR remote, The LED flickers.

Thanks for viewing.

Please write your questions or suggestions below.