Simplest Ipod Stand Ever

1,394

5

Introduction: Simplest Ipod Stand Ever

About: If you were here 2 or 3 years ago, you might remember me. I was that little kid who stood up for himself, and basically said f*ck the police, and ended up getting shot down. Well I'm 13 now, so all of that bus…

This is the most simplest ipod stand ever. There is only 16 basic pieces! you should have a basic set to make this.

Step 1:

These are the main, er, sections of the stand.

Step 2: Section Connection One.

you connect 2 with 4 and then you connect 4 with 5. You can stop here, but step 3 will make it sturdier and at a better angle.

Step 3:

Now you connect 1 with 2 then 2 with 3. Place your Ipod on 4 and see if the piece shown here fits your Ipod. You can modify or adjust it to fit yours. Mine is a 3rd generation nano with a green rubber case. I don't know what you will use this for but put it to good use!

Be the First to Share

    Recommendations

    • Microcontroller Contest

      Microcontroller Contest
    • Automation Contest

      Automation Contest
    • Make it Glow Contest

      Make it Glow Contest

    5 Comments

    0
    NYPA
    NYPA

    Reply 11 years ago on Introduction

    So you're a person who actually cares about simple stuff?

    0
    Lowney
    Lowney

    Reply 11 years ago on Introduction

    Simplicity is key in my opinion. I'm making a wooden ipod dock atm with an amp inside. I might post the amp.

    0
    cj81499
    cj81499

    11 years ago on Step 3

    cool and easy just the way I like it