I made a small office bedroom with a bed, chair, shelves, and a table.

Supplies

Inventor, 3-D Printer filament, and a computer

Step 1: The Room

When making the room, I worked my way up starting from the floor then making the stairs from said floor while extruding the second floor from the stairs later going underneath the upper floor to fillet the harsh corners.

Step 2: The Chair

The chair was made the same, bottom up, finer details after I got the base made.

Step 3: The Table

The table was made the same, bottom up, finer details after I got the base made.

Step 4: The Bed

The bed was made the same, bottom up, finer details after I got the base made but an issue I had was halfway through the project the measurements went from inches to centimeters so it screwed the bed up but other than that it was fine.

Step 5: The Final Build

This is the final project.