Hello everybody, these are the instructions for my snap book note book. This is the same as the https://www.instructables.com/id/snap-board-note-holder/ but bigger. If you want to make it smaller you can, but I like this size so that it can hold regular sized paper. This is nice if you don't want to make holes in your paper but you want to have them in one place. Now let's make this thing.

Please like, comment, subscribe and vote.

Step 1: Tools and Supplies

here is a list of the tools and supplies you will need

tools
scissors
small nail to make a hole in the tape measure
hammer

supplies
duct tape
card board
thin wire
cut pieces of tape measure

Step 2: Covering the Tape Measure With Duct Tape

now take one peice of tape measure and cover it with duct tape like in the picture

Step 3: Making the Hole in the Tape Measure

now it is time to make the hole in the tape measure
take a nail and make a hole close to the edge like in the pix

Step 4: Fastening the Tape Measure to the Card Board

now take the tape measure with duct tape on it and tape it to the card board, cover up the exposed tape measure with a piece of duct tape

Step 5: Connecting the Tape Measure to the Other Tape Measure With Wire

connecting the tape measure to the other tape measure with wire.

now thread the wire through the hole in the tape measure and twist it up and bend it to the back of the board.

Step 6: Covering It With Duct Tape

now that you have everything else down it is time to cover it up with duct tape. First take a piece of duct tape and cover up the wire and the ends of the duct tape covered tape measure like in the pix