Steampunk Spectacles
Intro: Steampunk Spectacles
The design, which is based on two cases and two covers broken mechanical stopwatches. The remaining parts are made of sheet brass, 1-2 mm., Brass rod with a diameter of 6-8 mm., Brass wire of 2-3 mm. and tubes of two telescopic antennas. In addition, using four standard screws and two springs.
The processing is performed using hand-held power tools, without the use of machine tools. Permanent connection of parts made with silver solder, using gas torch.
The processing is performed using hand-held power tools, without the use of machine tools. Permanent connection of parts made with silver solder, using gas torch.
40 Comments
Grimmy Grim 12 years ago
Grey_valentine 12 years ago
Avatar_I_Am 12 years ago
WAY to cool.
Really Very Nice!!
I am so impressed, and so depressed because I just don't have your talent for making thigs!!
Can you make one that I can buy?
Just kidding...
...not!
the_lonely_snake 12 years ago
the_lonely_snake 12 years ago
SIRJAMES09 12 years ago
the_lonely_snake 12 years ago
SIRJAMES09 12 years ago
the_lonely_snake 12 years ago
gogglerman 12 years ago
the_lonely_snake 12 years ago
TheHobbit81 12 years ago
gogglerman 12 years ago
TheHobbit81 12 years ago
Pity about ETSY, your work is much better than anything on there.
Keep up the good work.
P.S Do you have photos of your complete goggle collection? I think everyone would like to see that!
gogglerman 12 years ago
dohunagamez 12 years ago
bcanham-bennett 12 years ago
jboyd9 12 years ago
CadaverIncc 12 years ago
grey_badger1 12 years ago