Strain Relief - Wire to Board Connections

Introduction: Strain Relief - Wire to Board Connections

About: just have to figure out how all these things go together....

I've struggled with appropriate wire-to-board connections over the years.

Here's one of OMSI's mainstays that I've co-opted that I'd like to share: all you do is

Step 1: add a hole in your printed circuit board

Step 2: route the wire through the hole

Step 3: solder the wire to the board

in this case its a 22 gauge wire, 0.1" through hole for strain relief, and a 18 gauge pin hole to solder to.

Be the First to Share

    Recommendations

    • Chocolate Challenge

      Chocolate Challenge
    • Electronics Contest

      Electronics Contest
    • Digital Fabrication Student Design Challenge

      Digital Fabrication Student Design Challenge

    Comments