Introduction: Sugru Feet for Arduino

About: Melbourne Makerspace is located in Melbourne Florida - on the Space Coast! Our mission is to create a viable community and work environment for those who enjoy working on various types of projects. These proj…
Arduinos are great, but the exposed circuitry on the bottom could short out if accidentally touched to something conductive. We made tiny feet from balls to Sugru. Sugru is non-conductive, and it also lifts the Arduino up a little off the surface. 


1 Arduino
1-2 packets of Sugru (depending on the size foot you would like)

Step 1: Roll Sugru Into Little Balls

Roll into 4 small balls. Here we show two balls with an Arduino.

Step 2: Attach Feet to Arduino

Press the balls of Sugru onto the base of the Arduino. 

Turn it right-side-up and press onto a table or hard surface to flatten the balls into feet.

Allow to harden for 24 hours. 

That's it!