Introduction: Super Stereo Case

By see the shit i do.
About: AV Installer and Programmer by trade, modifier of cars and scooters for fun, tinkerer of all things electronic and otherwise.
So, here's an Instructable on how to build a basic case for a Stereo Mic, add some Potentiometers, XLR Jacks, LEDs, and Switches.

Parts List

2 XLR Jacks
2 50K Ohm Potentiometers
1 Toggle Switch
1 Large Red LED
2 Potentiometer Knobs
1 7"x3"x1.7" Project Box

Step 1: Drilling Holes

firstly you need to make sure all your parts are working and yadda yadda, use your DMM to check these. Next mark your holes and drill them

Step 2: Solder Your Shenanigans

Now its time to solder and de-solder your parts.
De-Solder your parts that you need to remove from the circuit board, such as:

Surface Mount Power Switch
Power LED
Stereo 50K B (Linear) Potentiometer
Audio Jack

Replace these with:

Toggle Switch
Giant Red LED
2 Mono 50K B (Linear) Potentiometers
2 Male Panel Mount XLR Jacks 
     this allows for individual output of the left and right mic/channel