Introduction: The Stepper Motor
These are the steps to make a stepper motor. Above is the finished project.
Step 1: Materials
First you get all your supplies.
1. a stepper motor
2.6 male to female wires
3. 1 arduino uno
4. one computer cord for arduino uno
Step 2: Where the Male to Female Wires Go in the Uno
- one goes in 8
- one goes in -9
- one goes in -10
- one goes in -11
- one goes in ground (after 13)
- one goes in 5v (on other side)
Step 3: Where the Wires Go on H Bridge
- one goes in 1 N1
- one goes in 1 N2
- one goes in 1 N3
- one goes in 1 N4
- one goes in 5 (on the other side)
- one goes in v (the one to the left of resistors)
Step 4:
Look up "Stepper motor code" then download on codebender.