The Office Catapult

Introduction: The Office Catapult

It´s the best catapult i´ve ever seen she trows paper at 7metres or more!!!
Trust in me

Step 1: Materials

What u need is :
- A sheet of paper
- 1 Binder clip 1-5/8".41mm
- A rubber band
- Tape
- 5 minutes

Step 2: The Catapult

This step is simple.

Step 3: Final Part

Finishing the catapult and shoting.

Be the First to Share

    Recommendations

    • Digital Fabrication Student Design Challenge

      Digital Fabrication Student Design Challenge
    • Fruits and Veggies Speed Challenge

      Fruits and Veggies Speed Challenge
    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest

    13 Comments

    0
    kayla242097
    kayla242097

    5 years ago

    cooooooooooooooooooooooooooooooooooooooool

    0
    giike3
    giike3

    9 years ago on Step 3

    cool but for step three be more descriptive next time

    0
    Air_Assassin
    Air_Assassin

    11 years ago on Introduction

    you shoud put a pen in the middle of the binder clip not where the hole is

    0
    pie R []ed
    pie R []ed

    12 years ago on Introduction

     Yeah, like bctl said, what's the point of the rubber bands? They wouldn't do anything there.

    0
    dombeef
    dombeef

    Reply 11 years ago on Introduction

    It is easier to push down the binder clip with it

    0
    bctl
    bctl

    12 years ago on Introduction

    just wondering what's the point of the rubber band. Is it to make it easier to pull down? and where did you wrap the tape?