Introduction: Twig

First you want to open a new document in SolidWorks.

Step 1:

Now you want to double click PART.

Step 2:

Now that you're in SolidWorks you want to click on front view.

Step 3:

If you're not already in sketch mode press the sketch button in the upper left hand corner. After that you want to press the line button.

Step 4:

You will want to draw a line.

Step 5:

Make sure that all of the lines are the same length and would seem the measurements of a twig.

Step 6:

Now add a line for where you want the curve of your twig to go.

Step 7:

Now connect and proceed.

Step 8:

You will want to press on the 3D-arc to enhance the curve.

Step 9:

Once you've pressed the 3D-arc button you will want to make a curve at the tip.

Step 10:

Now press 3D-arc again so that you can make a slight curve on the bottom.

Step 11:

Adjust the curve that you would like.

Step 12:

Now that you have everything to your needs, you will want to extrude. So press the extrude button.

Step 13:

Make sure that you don't make the twig to thick... because no one likes a thick twig.

Step 14:

This is what my twig looks like.

Step 15:

End result.