Twig
Intro: Twig
First you want to open a new document in SolidWorks.
STEP 1:
Now you want to double click PART.
STEP 2:
Now that you're in SolidWorks you want to click on front view.
STEP 3:
If you're not already in sketch mode press the sketch button in the upper left hand corner. After that you want to press the line button.
STEP 4:
You will want to draw a line.
STEP 5:
Make sure that all of the lines are the same length and would seem the measurements of a twig.
STEP 6:
Now add a line for where you want the curve of your twig to go.
STEP 7:
Now connect and proceed.
STEP 8:
You will want to press on the 3D-arc to enhance the curve.
STEP 9:
Once you've pressed the 3D-arc button you will want to make a curve at the tip.
STEP 10:
Now press 3D-arc again so that you can make a slight curve on the bottom.
STEP 11:
Adjust the curve that you would like.
STEP 12:
Now that you have everything to your needs, you will want to extrude. So press the extrude button.
STEP 13:
Make sure that you don't make the twig to thick... because no one likes a thick twig.
STEP 14:
This is what my twig looks like.
STEP 15:
End result.
2 Comments
tomatoskins 9 years ago
I love Solidworks!
EvolvedAwesome 9 years ago
Nice!