Introduction: Vector 1-X Prototype UAV
This is the Vector 1 autonomous quadrotor UAV; Controlled through inertial flight stabilization and an Arduino board over a cellular network.
Versions:
Vector 1-X: “Weaponised” sporting a basic setup, 540TVL camera, Arduino, GU344 IMU, and broadband modem; this sonic deterrent enabled quad-rotor UAV is designed specifically for police and riot control (please note, this is NOT available to the general public, and will ONLY be flown and tested on PRIVATE PROPERTY)
Vector 1-S : “Surveillance” with a 540TVL color camera, and a 680 TVL infra-red camera, this version is the same as above, only minus the Sonic Deterrent module .
Vector 1-AS: “fully autonomous surveillance” same as above, only sporting ultrasonic and laser rangefinders, infra-red detectors, upgraded autopilot and GPS capabilities, the Vector 1-AS can tackle any surveillance or data acquisition job you will throw at it
6 Comments
9 years ago on Introduction
Sir? your study has a similarity with mine :) Can I ask some favor? Will you give the step by step process and the device that you use in this project ? for me to have an Idea on how to start mine.... That would be a great blessing for me if you do. :) you can send it at my email yfc_jed17@yahoo.com or ivyghed25@gmail.com or via facebook https://www.facebook.com/gerold.delapena/media_set?set=a.115416655178935.29786.100001318038741&type=3
Thanks! God bless
11 years ago on Introduction
What was this about? I would have thought that one should have been able to tell what the "video" was about when watching it with the commentary switched off.
11 years ago on Introduction
Great Idea. However, this site is called "Instructables", not "Show and tell".
12 years ago on Introduction
Seems to be one the editors need to remove
12 years ago on Introduction
step-by-step ????
12 years ago on Introduction
Wouldn't it have made sense to finish the project, and then post a proper step-by-step Instructable?