Vr Out of Cardboard

Hi guys this is cherry777 now we are going to make a VR PLAYER by cardboard

Supplies

>CARDBOARD
>GLUE
>VELCRO
>LENS
>PAINTS
>TAPE
>PEN

Step 1:

Now take a cradboard and mark a 11.5 and 13cm and from the top take a 4cm and mark as shown

Step 2:

Now take a 7.3 and 8cm of cardboard x3 as shown

Step 3:

Mark a 9,13 cm of cardboard pice x2

Step 4:

Take a 7 and 12 .5 x2 piece of cardboard

Step 5: Cutting the 9 AND 13 Cm Board

▪Now mark a 1 cm of line from top of the 9 and 13 cm board and cut it
▪After that now mark a 4 cm from bottom and draw a radii circle around it and cut as shown

Step 6: Making and Assembling

Mark a 3cm in the 9,13 cm board and cut it

Step 7:

Now at the 7,12.5 cm board draw a equal line as a marking of plus symbol nad take a measure of 3 cm from bottom and cut the both pieces

And draw the size of your lens on the board and cut it as shown and stick it and on it stick the other piece and now done of making

Step 8: Assembling

Now stick thos all pieces with tape of glue gun as shown

And stick the lens piece in the mid of the boards

Now stick a round the lens piece as shown

Step 9: The Glue Mix

Now take a 2 tbsp of water and 1 tbsp of glue in a bowl and mix it

And also pick a paper and amake it as a piece

Now stick those piece of paper with the glue mix around the vr

After that leave it to dry for 20 min

Now after the dry well paint the vr

Step 10: Final

Now paste the velcro and done keep the phone and tight the velcro

It will work if you have gyroscope in your phone if not it can also work in google cardboard app

Hope you guys love it