Wireless Remote Using 2.4Ghz NRF24L01 Module With Arduino | Nrf24l01 4 Channel / 6 Channel Transmitter Receiver for Quadcopter | Rc Helicopter | Rc Plane Using Arduino

To operate a Rc car | Quadcopter | Drone | RC plane | RC boat , we always need a reciever and transmitter, suppose for RC QUADCOPTER we need a 6 channel transmitter and receiver and that type of TX and RX is too costly , so we gonna make one on our own with Arduino and nrf24l01 module and you can also use it to operate various servo's and this Rx Tx can be used for any circuit which needs a Tx and Rx.

Step 1: Gather Your Components

BUY PARTS :
BUY ARDUINO UNO:

https://www.utsource.net/itm/p/7199843.html

BUY oled display:
https://www.utsource.net/itm/p/8673610.html

BUY NRF24L01:
https://www.utsource.net/itm/p/6466212.html

BUY Joystick module:
https://www.utsource.net/itm/p/8673725.html

////////////////////////////////////////////////

2 x Arduino board https://www.amazon.in/gp/product/B015C7SC5U/ref=a...

https://www.banggood.com/UNO-R3-ATmega328P-Develop...

2 x Nrf24l01 - https://www.amazon.in/gp/product/B01HRKWPOO/ref=a...

https://www.banggood.com/NRF24L01-SI24R1-2_4G-Wire...

2 x Joystick module - https://www.amazon.in/gp/product/B01FFB6LQA/ref=a...

https://www.banggood.com/PS2-Game-Joystick-Module-...

1 x Oled Display- (optional) - https://www.amazon.in/gp/product/B01GK1OPMQ/ref=a...

https://www.banggood.com/0_96-Inch-4Pin-White-IIC-...

Step 2: Download the Schmatics and Code

Download code and schmatics from any of the link.

https://drive.google.com/file/d/0BzI1z5n4uz3GT1dlZ...

And extract the zip file

Note- if have any doubt regarding how to use these files or how to upload or any other problem refer the video provided.

Step 3: Prepare the Transmitter

After etracting the file you will get a folder named "tx" open it and then prepare everything as shown in the given schmatics in the figure then after connecting all together just upload the code named "Cheapass Transmitter.ino"

Step 4: Prepare the Reciever

so open the other folder named "rx" and then connect all together as shown in schmatics then upload the "rx.ino"

Step 5: Preparing PCB

After preparating and testing of RC Tx Rx on breadboard its time on solder everything according to the schmatics and then connect it all for final testing. You can watch it in video too and finally we made a awesome 4CH/6CH Tx Rx and we can modify it according to our need.

Note-For any confusion refer video