Wooden Initials Keychain

1,165

4

Introduction: Wooden Initials Keychain

About: I'm a Mechanical Engineer who has been a part of this community for over 10 years! My interests have evolved over time, and now center around 3D printing.

   This was a super quick fun project that I kind of did at a spur of the moment.  It is a small keychain cut out of 1/8" plywood  with a Dremel rotary tool.  The emblem shown is a combination of the letters "A" and "F", which are my initials.  It was tricky to get the hole in the center of the "A" to be triangular and look decent on such a small scale but it was fun.  I made the chain it hangs on out of some steel wire that I believe I took from an old TV antenna.  I painted it black using a single coat of craft acrylic paint and it was done!

Be the First to Share

    Recommendations

    • Edible Art Challenge

      Edible Art Challenge
    • Made with Math Contest

      Made with Math Contest
    • Laser Challenge

      Laser Challenge

    Comments