Introduction: Apple Floppy Dock
Floppy dock for apple I products.
Wath do you need?
4 things
11 floppy's
- glue ( supper glue) i used zap a gap thin
- an apple dock cable
- an apple i product ( i used an Ipad ) but it works with ipod and iphone too
Step 1: Make the Base
Take two floopys end glue it to getter to make a cube.
Now do this 2 two times , to make a square
Step 2: Make the Dock Part
Now make a hole in the floppy and put your doc connector inside.
Step 3: Tiangle ( the Support )
now take one ( i used 2 ) floppy as base.
than make an tiangle from thie floppys.
and glue the other floppy with to dock conector in place.
Step 4: Glue All
now glue alle your ports to getter.
but first make a hole in the base for your cable.
put a weigt in the cube ( for an ipod - iphone take 250 gram) ( for ipad take 500 to 600 gram)
and close it all up
Step 5: Enjoy
enjoy now
4 Comments
11 years ago on Introduction
foloppys? good though
Reply 9 years ago on Introduction
thx, now i'm working on a doc using old pcb's
10 years ago on Step 5
Very nice!!
Reply 9 years ago on Step 5
thx