3D Printed Bracelet: Steps

226

1

1

First, I created the template in sketch book pro,

Then, I 3D printed the "soon to be" bracelet,

Finally, I bent the plastic with a hair drier around a paper tube to fit around my wrist.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: 3D Printed Bracelet: Printing

The design printed very well, and there were few small plastic bubbles on the bracelet. Over all, the bracelet was smooth.

Step 2: 3D Printed Bracelet: Bending the Plastic

A bent the vegetable plastic (that's eco-friendly) by using a hot hair dryer and warming up the plastic, and wrapping it around a paper tube. The plastic is bio-degradable and made out of the pigment from vegetables.

Valentine's Day Challenge 2016

Participated in the
Valentine's Day Challenge 2016

Be the First to Share

    Recommendations

    • Book Character Costume Challenge

      Book Character Costume Challenge
    • Made with Math Contest

      Made with Math Contest
    • Cardboard Speed Challenge

      Cardboard Speed Challenge

    Discussions