Arduino 4 Wheel Drive Bluetooth RC Car Using UNO R3, HC-05 and L293D Motorshield With Coding and Android App

Today I am going to tell you about how to make a arduino 4 wheel drive bluetooth RC car using HC 05 , L293 motor shield , 4 DC motor, with coding and app for android to control car.

Component used :-

1-Arduino UNO R3

2-Bluetooth HC-05

3-Motorshield L293D

4-4 DC motor

5-Android mobile

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Tightly Secrew to Motor to Chasis and Connect Wires in Terminal of Motors

Step 2: Join the HC 05 Blutetooth Module Wires to Arduino (as Per Diagram)

Step 3: Insert Motor Shield in Arduino As Shown in Pic

Step 4: Connect Motor Wires in Motor Shield As Shown in Pic

Step 5: Connect Saperate Power Wire for Arduino and Motor Shield

Step 6: Connect Arduino to Pc or Android to Upload the Program Given in Video Discription

Step 7: Remove HC 05 Wires Before Uploading the Program

Step 8: Install the App Given in Video Discription and Your Rc Car Is Ready

Be the First to Share

    Recommendations

    • Instrument Contest

      Instrument Contest
    • Make it Glow Contest

      Make it Glow Contest
    • STEM Contest

      STEM Contest

    5 Discussions

    0
    None
    RajaNabilla

    Question 1 year ago on Step 7

    i cannot upload the program. help me... it stated that CPU speed not supported

    0
    None
    rajanishadRajS164

    Answer 1 year ago

    left side to left side pins and right to right