DIY 5 Ton Hydraulic Press

13,629

78

3

How to make a homemade hydraulic press with a car jack,  u channel steel (u beam) and threaded bar. It is not finished. The jack should be bolt down or attached to the base and the base to the table.

Share

    Recommendations

    • Optics Contest

      Optics Contest
    • Plastics Contest

      Plastics Contest
    • Make it Glow Contest 2018

      Make it Glow Contest 2018

    3 Discussions

    0
    None
    oohlah

    4 years ago

    Just a photo, needs more data.

    0
    None
    phydraulic

    5 years ago on Introduction

    It is very simple to install and use. It is really useful for household pressing purposes. Too small and high power! http://www.precisehydraulic.com/hydraulic-power-packs.htm

    0
    None
    FrankenPC

    5 years ago on Introduction

    Nice. I need one of these. It's small and light enough to be usable in a normal sized garage. Thanks!