Introduction: Dragon Finger Puppet
The dragon finger puppet goes with the felt castle!
(Just in case you don't happen to have a Lego dragon!)
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Use the Attached PDF Pattern to Cut Out the Pieces
Step 2: Sew.
Place the different-colored back piece between the two body pieces. Sew from the inner portion of the tail up to the nose.
Cut spikes from the back piece.
(Note: for the first six dragons, I cut the spikes out before inserting and it was much harder to sew!)
Step 3: Sew in the Flame.
If you happen to have red "Bendaroo" waxed fiber, make the flame from two small pieces.
If you have no Bendaroos, cut out a flame from red felt.
Stitch in place.
Step 4: Attach the Belly Piece.
Insert the belly piece. Stitch along one side. Leave the bottom unattached. (I just whip stitch along the bottom rather than ending a thread and restarting on the other side.)
Stitch along the other side.