How to Make a USB Port for Your Keyboard/ USEFUL IDEA!

12,395

205

6

About: https://www.youtube.com/dashboard?o=U

https://www.youtube.com/watch?v=5f5eixa400A&feature=youtu.be

Step 1: To Do a USB Port for Your Keyboard You Need!!!

In today’s video I am going to to hack an additional DIY USB port Into your keyboard at home.
USB hub https://goo.gl/bojyKo

Step 2: Having Resorted to DIY Modding of You Keyboard You Will Simplify Your Everyday Use of USB Port!

Because you won’t need to stretch too far to reach a port on the front or back panel of your computer case! All you need is always at hand!

Step 3: This Modding Will Also Serve You As a Reminder.

Your memory card reader is always within your sight and will certainly not forget to take it to the school or university!

Step 4: USB Port for Your Keyboard Is Ready!!!

Share

    Recommendations

    • PCB Contest

      PCB Contest
    • Make it Glow Contest 2018

      Make it Glow Contest 2018
    • First Time Author

      First Time Author

    6 Discussions

    0
    None
    fraser02

    2 years ago

    cool as!

    0
    None
    gomibakou

    2 years ago

    Normally keyboards are USB 1.1. The HUBs are 1.1/2.0. I dunno if there could be a problem joining them as you did, but the safest way is desolder the keyboard wire, soldeer it to the HUB output, then solder the keyboard controller directly to your HUB. In that way the HUB will be behaving as the keyboard was attached to it, that is perfectly compliant with the USB specficication

    1 reply
    0
    None
    prototype_mechanicgomibakou

    Reply 2 years ago

    1. take usb2-usb3 hub.

    2. unsolder keyboar-to-pc cable

    3. solder cable to hub

    4. solder keyboard electronics to usb hub

    profit