Introduction: [OMGFLY] How to Build GEPRC-IX5 Racing Drone
ix5 from omgfly
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: GEP-IX5 Installed Components List =====
GEPRC-IX5 Wizard Fairy through the rack (the latest)
GEMFAN RT2205 2300KV motor
GEMFAN MAVERICK 24A ESC
GEMFAN MASTER Master Paddle 5045 * 3 (latest)
FOXEER 1190 NEW ARROW FPV camera
FOXEER TM25 Figure 25/200 / 600mw adjustable
FOXEER 5.8G right-handed antenna
F3 EVO fly control brush BETAFLIGHT
DEVO RX716 PPM Receiver
4S 1300-1500 battery
Step 2: = Key Out of the Box Introduction =====
IX5 Wizard, is X models, 5 inch pitch 200 wheelbase,
TPU material with 3D print hood, reduce wind resistance! Under the battery, the top 35 degrees tilt camcorder installation and so on ...
Step 3: FRAME
THE LAST IMPORTANT
Side panels 2mm, equipment and roof 1.5mm