USB Rubber Duckie!

4,386

1

5

Hello! This is my very first but most definitely not my last instructable. This project took me about 1-2 minutes to build.(I probably could have finished it sooner if I wasn't running around the house in search of a rubber duckie!!!)

Step 1: Parts List

1. Rubber Duckie
2. flash drive
3. scissors/utility knife
4. sharpie

Step 2: Measuring the Hole

First, trace the outline of the flashdrive on the duck's bottom.

Step 3: Cutting the Hole

Now, get your utility knife/scissors and cut along the inside of your trace.

Step 4: The Final Step = Inserting the Flashdrive.

The title of this instruction pretty much explains itself."Stick the flashdrive into the duckie's butt."

Step 5: TADA!

You're done!!!!!! :D

Step 6: Grandma Duck!! :P

Share

    Recommendations

    • PCB Contest

      PCB Contest
    • Make it Glow Contest 2018

      Make it Glow Contest 2018
    • Toys Contest

      Toys Contest

    5 Discussions

    you should cut off its head. then put the usb stick where its head would have been. when you put it in the computer it looks like someone jammed its head into ti