Anybodysguess's instructables
Achievements
10K+
Views
Earned a bronze medal
1+
Featured Instructable
Earned a bronze medal
Contest Winner
First Prize in the
Share Your Space Challenge
- Anybodysguess commented on gzumwalt's instructable Single Cylinder Air Engine Smaller Edition2 years ago
- Anybodysguess commented on gzumwalt's instructable Single Cylinder Air Engine Smaller Edition2 years ago
View Instructable »I began printing this, but I beleive the cylider is wrong, it doesn't match your pictures, and doesn't fit the base.
- Anybodysguess completed the lesson Next Steps for Photography in the class Photography Class2 years ago
- Anybodysguess enrolled in Photography Class2 years ago
- Anybodysguess favorited Modern Bedroom by Gusarin4 years ago
- Anybodysguess favorited Arduino Nano based Microbot by PaulMakesThings4 years ago
- Anybodysguess favorited Knock Block by jkestner4 years ago
Done printing, not done sanding, probably not the best model to use to redial in my printer after rebuilding it. Anyways, is the valve arm too long? The valve goes all the way in, but the arm is too long and doesn't line up with the cam.