9300,00470
Electrical Engineer | Woodworker | Robot Builder | Maker | Fixer
invisiblelight386's instructables
Achievements
10K+
Views
Earned a bronze medal
- invisiblelight386 commented on invisiblelight386's instructable Projector Bulb Conversion to LED
The only problem I would with using the projector power is the 1000V start up voltage - I didn't want to mess with that too much and burn out any LEDs.
I would try bringing Pin 3 (Lamp Miss) to 5V and see if the projector stays on. You would need to pull up pin 3 to 5V on the control side, and not the power unit side.