Tell us about yourself!
Thanks Silvius! By the way, one of my BEST childhood friends was named Silvio... by coincidence hehehe!) But... I wonder, why this happened, and I wouldn't be able to recover it? Usually a reset SHOULD restore everything ... but why doesn't work???
I used this device for a long time, and I'm very satisfied of it. But, this morning, I tried to recalibrate it, using the internal menu procedure. After the calibration, all goes well, but I get a character "I" corrupted (see image)Is there any possibility to "recover" that character? Or a "software reset"???
WD-40 works for me in zillion of cases...after one can soap & rinse well..
Hi!As a modeller, I was looking around how to make ADHESIVE (to paper) a plastic surface (like styrene). I found your interesting 'ible ad I was wondering if it could be used for this purpose.I was thinking to make that 'goo and spread it over the styrene sheet using a card and then apply the printed piece of paper.Also wonder if your solution could loose it's adhesiveness during time, let's say: years.
Fantastic and incredibly "imaginative" 'ible...I will try by myself just to see it working!!!! congratulations!
DIY Glow 3D Printer