Introduction: Paper Pencil Shooter
please take note that this is my first Instructable and that I am NOT responsible for anything you do with this. i hit my brother in the back of his leg while he was standing and he collapsed on the floor, so with the right rubber band it can hurt a LOT. so on with the instructions! (sorry about the blurry pictures, my hands were shaky.)
materials for this project:
81/2x11 paper
a scissor or a box cutter
ruler (recommended)
strong tape
a rubber band
a pencil, duh
materials for this project:
81/2x11 paper
a scissor or a box cutter
ruler (recommended)
strong tape
a rubber band
a pencil, duh
Step 1: The Main Barrel
this how to make the main part of the gun
#1:line up the shorter edge of the paper with the pencil and mark a line a little below the point the whole way up the paper
#2:cut along the line
#3:roll up the paper into a tube, using the pencil as a guide
#4:tape the flap of paper down, so it stays in place
#1:line up the shorter edge of the paper with the pencil and mark a line a little below the point the whole way up the paper
#2:cut along the line
#3:roll up the paper into a tube, using the pencil as a guide
#4:tape the flap of paper down, so it stays in place
Step 2: The Firing Machanism Thingy
more step by step instructions
#1:cut your rubber band
#2:hold the band accross one end of the tube
#3:tape the ends of the band to the tube
#4: youre done!!!
#1:cut your rubber band
#2:hold the band accross one end of the tube
#3:tape the ends of the band to the tube
#4: youre done!!!



