Rc Plane Landeing Gear
Intro: Rc Plane Landeing Gear
so i just built a 3 channel park flyer using foam board from the dollar tree and when i was done the control serfeces hit the table so one thing led to another so i made landing gear for my micro parkflyer using only 1 cable tye and epoxy
STEP 1: Building the Rear Landing Gear
so building the rear landing skid is just zipping the tye till it makes the desired size and cut the end off around 3/8 and glue on the plane and fly
hope you enjoyed this project please comment for more instructables
3 Comments
quincy trott 10 years ago
ps this plane is a scratch built that i made from a champ:p
Sajjad_A 8 years ago
Hi I have a champ too and I wanted to take it apart and build a ft mighty mini speedster (http://flitetest.com/articles/ft-mighty-minis). From your experiences, how easy is it to take apart the champ & electronics and put it together again? Are the electronics all in one piece or separately attached? Thanks!
quincy trott 8 years ago
will be enough power to fly the mini. But the electronics are all one piece except the motor, that just plugs right into the side. its really a cake walk.