Square Paracord Lanyard

37,889

144

12

Introduction: Square Paracord Lanyard

Square paracord lanyard

Step 1:

Take 57in of paracord. cut it in half and take inner string out

Step 2:

On one cord find the center and tie a loop in it like this.

Step 3:

Holding the loop upside down place the other cord on the loop section of the cord.and cross the bottom cord as shown.

Step 4:

Perform on both sides of top cord as shown.
(pull them tite)

Step 5:

Once this is done it should look like this.
Continue steps until desired length.

Step 6:

When done cut the extra cord off.

Step 7:

Then with a lighter melt the ends.

Step 8:

Now you are finished.
Enjoy!!!!!!

Paracord Contest

Participated in the
Paracord Contest

1 Person Made This Project!

Recommendations

  • Plywood Challenge

    Plywood Challenge
  • Battery Powered Contest

    Battery Powered Contest
  • Plastic Contest

    Plastic Contest

12 Discussions

0
anonomuspe
anonomuspe

2 years ago on Step 3

no offense but this is really blurry

0
anonomuspe
anonomuspe

Question 2 years ago

Why do u have 2 take the center out?

0
abstracted
abstracted

5 years ago

my father was a military paratrooper when I was growing up, he`d have these all over his gear (lanyards, zipper pulls etc) and showed us kids (4 of us, me the youngest) how to make them. I am now 51 yrs old and lost my father a handful of years back. It was very memorable for me to make a few of these lastnight. It`s been so long I forgotten how to do these. I THANK YOU !!

0
bak91214
bak91214

7 years ago on Introduction

used the inner strands to make an america theme

thanks

20130202_215858.jpeg
0
bak91214
bak91214

7 years ago on Introduction

used the inner strands on mine to make an "america" theme

thanks for the instructable!

0
sipcat
sipcat

10 years ago on Introduction

Thanks for the idea. I do gimp so stitch was easy, I angled mine creating a circle stitch.

0
boston09
boston09

10 years ago on Step 8

what swiss is that