16 Channel Servo Controller (Raspberry Pi)

Introduction: 16 Channel Servo Controller (Raspberry Pi)

About: the Raspberry Pi is Awesome!

How to control multiple servos using a 16-Channel driver with the raspberry pi.

*NOTE: Servo Controller input voltages should be 5-6 volts instead of the suggested 9 volts

Step 1: Parts

RPI 3 - https://amzn.to/2VA9pQY

4 Amp Power Adapter - https://amzn.to/2CTptWu

16GB micro SD - https://amzn.to/2SFMwd3

16-Channel Servo Controller: https://amzn.to/2CasoIK

6 x 1.5V AA Battery Holder: https://amzn.to/2LW10mq

5.5x2.1mm Male+Female DC Power Socket: https://amzn.to/2VA5ZNW

120 pcs jumper cable: https://ebay.to/2VAb9cY

9g Servos: https://amzn.to/2VAvcrF

Step 2: Setup

Be the First to Share


    • Hour of Code Speed Challenge

      Hour of Code Speed Challenge
    • Reclaimed Materials Contest

      Reclaimed Materials Contest
    • Unusual Uses Contest

      Unusual Uses Contest