Introduction: 1D - LED Pong: a Fun Electronics Project

By

In this project we will be making LED PONG using Arduino, this is a two player game where each player must push their button before the ball (LED) reaches the red led. If the player waits until the yellow led and pushes the hit button it will shot the ball extra fast so watch out!!! After each bounce the speed of the ball increases until it's a battle to the DEATH!!

Supplies

9 LEDS (2 Red, 2 Yellow, 5 Green)

1 Arduino Uno

2 push buttons

1 Buzzer

1 220 ohm resistor.

1 9V batter and connector

wires,

Step 1: Breadboarding (Create the Circuit)

First create the circuit using a breadboard follow the circuit diagram.


Link to tinker cad files https://www.tinkercad.com/things/5bt8qxqKSwQ-led-pong

Attachments

Step 2: Create the Box

I used a laser cutter to cut the box out of 3mm wood panels, the below cad files are below including the drawings in google sketchup

Step 3: Solder the Wires

Solder the Leds and other components together, use header pins to plug into the ports of the Arduino

Step 4: Upload the Code

After soldering all the components upload the code via USB, change any code as needed.

files and code here.

https://drive.google.com/drive/folders/1FgFhpXPknlWOLMVhsUXVpSeN4DnNz5C3

Have fun and enjoy!!

At Newson's Electronics, we're all about reducing e-waste through repairs, one gadget at a time! If you enjoy my content, consider supporting my youtube channel by exploring my other offerings:

Newsons Electronics - YouTube


📚 Books by the author:


THE LOST SCROLL - https://amz.run/93Gm

HEART OF STONE - https://amz.run/6kXq

UNLOCK YOUR MIND - https://amz.run/6kXr

OVER THE GREAT WALL - https://amz.run/6kXt

Stay connected with me:

👍 Facebook Page:  / newsonselectronics  

💻 Website: https://sites.google.com/view/newsons...


Thanks for watching and supporting Newson's Electronics – let's dive into the world of tech together! 🔧🚀


Attachments