Arduino Smile MAX7219 Matrix LED Tutorial

Introduction: Arduino Smile MAX7219 Matrix LED Tutorial

About: someone who likes electronics Yt channel : IG 1 : sottong_teknik

In this tutorial "Controlling a Led Matrix Using Arduino". I show you how to use Led matrix displays using Arduino.

And in this article, we will learn to make smile emoticons using this matrix display using Arduino too.

The ingredients used are still the same as the previous article. so right away we start the tutorial.

Step 1: Required Component

this is a list of the components needed:

  • Led Matrik
  • Arduino Nano
  • Jumper Wire
  • USBmini
  • Project Board

Required library:

  • LedControl

Step 2: Scheme

To assemble the components see the schematic drawing above, you can also see the information below:

Led Matrix to Arduino

VCC ==> +5V


DIN ==> D6

CS ==> D7

CLK ==> D8

After completing the component assembly, proceed to the programming process.

Step 3: Programming

Use the code below to make a smile emoticon in the dot matrix:

#include "LedControl.h"

/* Now we need a LedControl to work with. ***** These pin numbers will probably not work with your hardware ***** pin 6 is connected to the DataIn pin 8 is connected to the CLK pin 7 is connected to LOAD We have only a single MAX72XX. */

LedControl lc=LedControl(6,7,8,1);

unsigned long delaytime=100;

void setup() { lc.shutdown(0,false); lc.setIntensity(0,8); lc.clearDisplay(0); }

void smile(){ byte a[8]={B00000000,B01100110,B01100110,B00000000,B00000000,B01000010,B00111100,B00000000};

lc.setRow(0,0,a[0]); lc.setRow(0,1,a[1]); lc.setRow(0,2,a[2]); lc.setRow(0,3,a[3]); lc.setRow(0,4,a[4]); lc.setRow(0,5,a[5]); lc.setRow(0,6,a[6]); lc.setRow(0,7,a[7]); }

void loop() { smile(); }

Step 4: Result

For the results can be seen in the picture above.

Be the First to Share


    • Halloween Contest

      Halloween Contest
    • Retro Tech Challenge

      Retro Tech Challenge
    • Plastic Challenge

      Plastic Challenge