Bed Frame

I made a small bed for the contest big and small, i did this because it is something everyone uses everyday

Supplies

i used Onshape to make my design

Step 1: Base

First i made the base, were you would lay the mattress. I made the measurements in inches 4x3, and i made an extrusion by 0.3 inches

Step 2: Legs

Second I made the legs for the bed I made a pair of bigger legs and a pair of smaller legs. I made both with a round trim at the tip. The bigger legs are 3.5 inches tall and 0.6 inches wide. The smaller legs are 1.75 inches tall and also 0.6 inches wide.

Step 3: Side Plank

I made two side planks to hold the base in place, I made them 4 inches tall and 0.6 inches wide and i extruded them 0.15 inches

Step 4: Small Planks

i made these smaller planks to hold the legs and base in place. i made them 2.4 inches tall and 0.5 inches wide and i also extruded it by 0.15 inches