Poor Man's Camera Flash Diffuser

Introduction: Poor Man's Camera Flash Diffuser

About: Hey! i am High school student studying and like to make new things and do inventions

i am going to show u how to make diy flash diffuser for point and shoot cameras step by step

Step 1: Material Required

. cardboard tube
. tape or glue
. camera
. paper
. scissor

Step 2: Cutting the Tube

cut the tube in less half as ur camera size see in figure/image showing how to cut

Step 3: Cut Tube From Bottom Edge

cut tube from bottom edge see in figure/image

Step 4: Cutting the Tube for Paper Mount

Step 5: Glue or Tape the Paper to Cardboard

glue or tape the paper to cardboard see in figure/image

Step 6: Flash Diffuser Is Now Complete

attach the flash diffuser to ur camera and take photos

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge

    3 Discussions

    0
    DaddysGal22
    DaddysGal22

    5 years ago

    Go Nikon Coolpix! Loved your instructable!!!

    15, 7:50 AM.jpg
    0
    MikB
    MikB

    7 years ago on Introduction

    Poor man's? Luxury! :)

    I just hold a small piece from an A4 copier paper sheet over the flash, doubling it over if necessary to cut the light down -- for close-up work where the flash will dazzle out! -- I keep it tucked in the camera case when not needed!