ENC28J60 Using Ethernet With Arduino

11,822

16

1

Introduction: ENC28J60 Using Ethernet With Arduino

WOW, I've been working hard to make this one work, flowing guides and schematics and Arduino libraries...
This is the only way i made it work for me, using the EtherCard Library after carefully flowing the Arduino pinout schematics.

ENC28J60 Arduino Uno
VCC ==> 3.3v
GND ==> GND
RST ==> Reset
SCK ==> D13
SO ==> D12
SI ==> D11
CS ==> D10
CLK ==> D8

Hope it will work for you too...

Arduino Contest 2016

Participated in the
Arduino Contest 2016

Be the First to Share

    Recommendations

    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest
    • Digital Fabrication Student Design Challenge

      Digital Fabrication Student Design Challenge
    • Make It Modular: Student Design Challenge

      Make It Modular: Student Design Challenge

    Comments

    0
    SimonF81
    SimonF81

    5 years ago

    Ahh you saved me. I was struggling to get the ethernet to work, turns out I had it wired incorectly, your wiring did the job thanks.