Firehawk: the 3/2 Step Plane

Introduction: Firehawk: the 3/2 Step Plane

About: Our/my game making website coming out on 2021! And it is a public chat room so don’t say anything bad.

This plane is a stunt plane. IT DOES LOOPS!!!

Supplies

Scissors, paper, tape (not shown)

Step 1: Make the Nose

Fold in half, then fold the corners down to the middle crease.

Step 2: Make the Wings

Now, fold in half.
Next, fold the wings down, like this.
Match this wing to the other one.

Step 3: Finish the Plane

First, fold the winglets up.
Next, fold the wings and winglets up.
Next, cut the tail like this: /
FINALLY: put tape here, and throw at a 45 degree angle.
NOW YOU’RE DONE!!!!

Be the First to Share

    Recommendations

    • Halloween Contest

      Halloween Contest
    • Microcontroller Contest

      Microcontroller Contest
    • Back to School: Student Design Challenge

      Back to School: Student Design Challenge

    4 Comments

    0
    SH00PA142
    SH00PA142

    Tip 2 years ago

    Make sure the tail is 1 and 1/2 inches tall and the wings are 5 inches long.

    0
    SH00PA142
    SH00PA142

    2 years ago

    Also, please show a picture of the finished product.

    0
    Penolopy Bulnick
    Penolopy Bulnick

    2 years ago

    Thanks for sharing your airplane :)

    0
    SH00PA142
    SH00PA142

    Reply 2 years ago

    You’re welcome. Check out: how to Make an Electronic Warfare tail for it too. It’s not made by me, but it flys with more stunts if it’s on.