How to Draw Steve

Introduction: How to Draw Steve

In this tutorial I will show you how to draw the default Minecraft skin!!

Step 1: Supplies!

You are going to need a ruler, coloured pencils in these colours: peach, mahogany, brown, and violet. Also you will need a photo of Steve and a pencil.

Step 2: Hair and Folding!

Measure the paper. Make it a nine by eight size paper or nine by nine I did nine by eight.
draw the hair on the top of your paper three inches down on both sides and nine across on top.

Step 3: Eyes and Ears and Mouth and Nose!

You just went down three inches for the hair. One inch below that and an inch in draw a two inch by one inch rectangle. Draw a vertical line in the centre of the rectangle. Repeat on other side.
Now go to the bottom corner of the page. Two inches over and one inch up draw a four by one inch rectangle on top of this rectangle draw a two by one inch rectangle forming a hat shaped thing.

Step 4: Colour!

Colour the eye lightly with violet. Leave the Eye part closest to the edge of the page blank. The four inch rectangle is lightly coloured with mahogany then lightly coloured with brown.
The nose is just lightly coloured with brown. The hair can be coloured normally with brown. the skin itself is a peach colour.

Step 5: Your Done!

Yay! Hope you enjoyed!

Step 6:

Step 7:

Be the First to Share


    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Stick It Challenge

      Stick It Challenge
    • Origami Speed Challenge

      Origami Speed Challenge