How to Make an Origami Spaceship

15,624

1

2

Introduction: How to Make an Origami Spaceship

First, you need a rectangle of paper. You might need to cut or fold the paper in half so that the ratio of the breadth to the length is 1:7 ( the length can be longer, it doesn't matter)

Step 1:

Next, fold down one corner of the paper. Unfold and repeat on the opposite side. Create a '' waterbomb base''  . ( See picture

Step 2:

Repeat on the opposite end. Now, take one of the folded ends and fold the two flaps to the middle ( see picture)

Step 3:

Fold in the two rectangular edges on the left and right ( see picture) i'm bad at explaining things.

Step 4:

Nearly done! Now fold the whole thing in half, so that the folded waterbomb base rests on top of the unfolded base. Tuck both the tabs of the folded base into the '' pockets'' of the unfolded base.

Step 5:

Finished! This origami is popular among schoolchildren in Singapore. Its inspired by the Japanese racing car series '' Crush Gear''.


Be the First to Share

    Recommendations

    • Stone Concrete Cement Contest

      Stone Concrete Cement Contest
    • Leather Challenge

      Leather Challenge
    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest

    2 Comments

    0
    awinter3
    awinter3

    10 years ago on Step 3

    This is an epic fail! You're finished product of the origami spaceship is only half of what the real one is supposed to look like! Yes, I'll give it to you that it ALMOST looks like it, but even still, IT'S A FAIL!

    0
    sageserver
    sageserver

    12 years ago on Introduction

    For step four, make the fold higher up.  then squash fold the two "wings" and fold the corners in on the back of the spaceship.  It looks tighter.