Introduction: How to Make Your LongShot Shoot All Nerf Darts.
Hello this instructable will teach you one of the coolest things you can do to your Nerf LongShot. When I was a kid back in 2006 when the longshot was released I thought that it was impossible to make a LongShot to shot DartTags or SonicMicros. It can still shoot Streamlines.
Things you need.
1. A Hacksaw.
2. A Dremal.
3. A lot of time.
We have work to do.
Step 1: Unscrew Your Gun.
This is pretty easy.
Step 2: Take Your Bolt.
The bolt is the longest part in this gun.
Step 3: Hacksawing the Bolt.
First take your hacksaw and start cutting where the bolt is held by the boltsled.
Step 4: Now Time for the Dremal.
You need to dremal the bolt inside the dart chamber so that it will fit DartTags.
Step 5: Now More Dremaling.
Then you need to dremal where the dart tooth is but dont harm the dart tooth.
Step 6: Your Done.
Good job if you did it right it should fire all darts.
17 Comments
10 years ago on Introduction
how well does this really work? can i put the other darts in the clip too? or do they have to be hand fed into the bolt? this would be really cool if it works well
Reply 10 years ago on Introduction
yes it works..and the clip will jam sometimes
Reply 10 years ago on Introduction
sometimes is better than all the time. this would be great during a nerf war. its like a gun that shoots .223 and .306 at the same time
Reply 10 years ago on Introduction
Yes it is, but you might have to tweak it some.. I had to. I still wished i had this gun it was my baby lol
Reply 10 years ago on Introduction
It's a good lookin gun
11 years ago on Introduction
thats not the bolt, it's the plunger, the bolt is the bar that goes through
Reply 11 years ago on Introduction
imeant bolt sled sorry idont even do nerf anymore
11 years ago on Introduction
wats with the screws
11 years ago on Step 2
cool pjs
Reply 11 years ago on Step 2
THX
Reply 11 years ago on Step 2
wish i had them they look rly comfy
12 years ago on Step 5
Sand down the ridges on the dart tooth as well.
Reply 12 years ago on Step 5
no take out the dart tooth
Reply 12 years ago on Step 5
While you have it out, you might as well sand the two ridges on it, because the tip of suckers, whistlers,ect, will make the dart longer.
12 years ago on Step 5
This will defiantly come in handy,
Reply 12 years ago on Step 5
Yeah it does my intergrated longshot now shoots every thing but it isn't flawless.
12 years ago on Introduction
Subscribe