Knex Sword V3

Introduction: Knex Sword V3

This is my knex sword which is my best ever, and it is better then any other 1 I have ever seen.

Good
sturdy
long
looks good

Bad
takes a lot of pieces

Here is a link for v2 https://www.instructables.com/id/knex-sword-1/
Here is a link for v1 https://www.instructables.com/id/Knex-sword-v1/

Step 1: Pieces

72 green rods
34 white rods
3 blue rods
42 yellow rods
3 grays 2 slots connectors
3 red connectors
3 green connectors
66 yellow connectors
6 white snowflake connectors

Step 2: Blade

The blade 30in.

Step 3: Handle

The handle is the perfect size for me.

Be the First to Share

    Recommendations

    • 3D Printed Student Design Challenge

      3D Printed Student Design Challenge
    • Space Contest

      Space Contest
    • Rocks, Gems, and Stones Speed Challenge

      Rocks, Gems, and Stones Speed Challenge

    7 Comments

    0
    warsoldier94
    warsoldier94

    12 years ago on Introduction

    i see you got the idea from the Kne'x Sword of Awesomeness..look it up...yours looks very similar to that

    0
    Shadowpom
    Shadowpom

    Reply 12 years ago on Introduction

    Actually I didn't but you are right they do look similar in the handle.

    0
    deadaccount
    deadaccount

    Reply 10 years ago on Introduction

    btw what happened to the Knex Sword of Awesomeness? did he take it off?
    i know im a bit late to reply but i wanted to build it again and i cant find it.

    0
    stopanator
    stopanator

    12 years ago on Introduction

    i commented on your first version and this has to much pieces tho

    0
    Shadowpom
    Shadowpom

    Reply 12 years ago on Introduction

    Then try my v2 its almost as good and uses less than half the pieces