Introduction: LED CUBE Arduino 5x5x5
5x5x5 LED CUBE Arduino Uno, using only 3 pins of Arduino, 6 shift registers 595N
Step 1:
Schematic
Step 2:
Arduino Uno
125x Leds
6 x 74HC595N
5 x BC337
5 x 10 Ohm resistors
290 tiepoints breadboard
810 tiepoints breadboard
prototype board 6x8 cm
6 x AA batteries
6AA battery box
2.54 male header
wires (male to male, male to feemale)
Step 3:
Step 4:
Attachments

Participated in the
Battery Powered Contest
1 Person Made This Project!
- sayantan06 made it!
17 Discussions
1 year ago
Thanks for the project. Especially, you have the schematic...!!!
2 years ago
Is there anyone who managed to make the code work? I used the same schematics and I can't get the cube to work with the code which Eagle199393 posted in this instructable.
3 years ago
What are the steps for doing this one?
3 years ago
plzz someone send me the full code cause i can't get it
thanks :D
5 years ago
good!
5 years ago
what a Transistor to replace BC337N ????
5 years ago
I'm don't understand STEP 1
can you send me : connection diagrams foot 74HC595
thanks you so much!!!!
5 years ago on Introduction
There is no error in the code, but he has connected some pins on HC595N that not show in the figure, such as
pin 16 on each HC595 to VCC and pin 8 on each HC595 to GND.
You just have connected these pin and it'll work.
5 years ago on Introduction
Code still doesnt work. does anyone have an alternate code? I built this for a school project and it doesnt work...
5 years ago
Can anyone provide the correct code please? o/
5 years ago on Introduction
who can provide the correct code?
5 years ago on Introduction
I have made the cube according your schematic. but it cannot work.
6 years ago on Introduction
The code is wrong!
6 years ago on Introduction
how to change the text in cube in arduino uno software....plese help...me...my mail id xavierscientist@gmail.com
6 years ago on Introduction
how to change the text in cube in arduino uno software....plese help...me...my mail id xavierscientist@gmail.com
6 years ago on Introduction
how to change the text in cube in arduino uno software....plese help...me...my mail id xavierscientist@gmail.com
6 years ago on Introduction
Cool!